0261S19721 670104910C engine control unit for Maserati Levante 3.0 V6 Bosch
We offer a genuine, used and fully tested 0261S19721 670104910C engine control unit for the Maserati Levante 3.0 V6. This Bosch ECU is also identified by the number 670104910 and is intended for selected 3.0 V6 petrol versions, including Maserati Levante models equipped with an engine from the F160 family.
This Maserati Levante 3.0 engine control unit has been technically inspected, prepared for installation and is supplied with a warranty. Before purchasing, compare the references shown on the original module: 0261S19721, 670104910C or 670104910. Different ECU versions may have been fitted to Maserati vehicles, so compatibility should be confirmed primarily by part number rather than only by vehicle model, year of manufacture or engine capacity.
Which vehicles are compatible with the 0261S19721 670104910C ECU?
The control unit may be suitable for selected versions of:
- Maserati Levante 3.0 V6 petrol
- Maserati Levante 3.0T V6
- vehicles produced approximately between 2016 and 2019, depending on the version
- V6 engine from the F160 family
- ECU references: 0261S19721, 670104910C, 670104910
The most reliable selection method is to compare both the Bosch number and the Maserati number with the original control unit. If the reference shown on the label is identical, the likelihood of compatibility is highest.
Typical symptoms of a faulty Maserati Levante 3.0 ECU
- no communication with the engine control unit,
- the vehicle does not start or stalls shortly after starting,
- immobiliser, ignition, injection or throttle-related faults,
- irregular operation of the 3.0 V6 engine, loss of power or limp mode,
- problems caused by water ingress, an electrical short circuit or damaged ECU electronics.
Depending on the situation, the control unit can be prepared for the vehicle, including cloning data from the original ECU, provided that the original module can still be read. This allows the replacement control unit to be matched to the vehicle and reduces the risk of installing an incompatible version.
FAQ – 0261S19721 670104910C Maserati Levante 3.0 ECU
Does the 0261S19721 control unit fit the Maserati Levante 3.0 V6?
Yes. The 0261S19721 control unit is used in selected Maserati Levante 3.0 V6 versions, but compatibility must always be confirmed using the reference on the original ECU. The most important numbers are 0261S19721, 670104910C and 670104910.
Does the 670104910C Maserati Levante ECU require programming?
In many cases, a used 670104910C control unit contains data from the previous vehicle and may therefore require preparation, adaptation or cloning. The best solution is to compare the references and determine whether the original control unit can be read.
Can the Bosch 0261S19721 control unit for Maserati Levante be cloned?
Yes. If the original control unit can still be read, cloning the Bosch 0261S19721 ECU is possible. This allows the immobiliser data and vehicle configuration to be transferred to the replacement control unit.
How should the 670104910 engine control unit be selected for a Maserati Levante 3.0T?
When selecting a 670104910 control unit for the Maserati Levante 3.0T V6, check the Bosch number, Maserati number, engine version, year of manufacture and software version. The vehicle model alone is not sufficient because visually similar control units may differ internally.
Is the Maserati Levante 3.0 670104910C control unit tested?
Yes. The offered Maserati Levante 3.0 670104910C engine control unit has been tested, prepared for further installation and is supplied with a warranty. If required, the module can also be prepared for a specific vehicle.
