What you get when you buy 0281012881
A used Bosch engine ECU (55209436) for the Fiat Ducato 2.3 Multijet, prepared as Virgin, which codes itself to the vehicle.
Virgin Plug & Play
ECU 0281012881 is prepared as Virgin Plug & Play – after fitting it codes itself to the vehicle and immobiliser, with no programming (condition: matching numbers and a working immobiliser). On request an IMMO OFF version is also possible: the car runs, but the immobiliser error and red warning light remain until the immobiliser is programmed.
Symptoms – diagnostics first
Before you buy, check with diagnostics whether the ECU is to blame. A faulty ECU may be indicated by:
- failure after water ingress or a short circuit,
- no power despite good fuses,
- no communication with the ECU,
- no start and no injector control.
The cause may also be the wiring, power supply or sensors – diagnostics before purchase are essential. A guide to typical faults of Bosch ECUs in the Ducato 2.3: Fiat Ducato 2.3 JTD Bosch ECU failure – solutions.
Numbers on the label
The label of your old ECU must carry the same two designations:
- Bosch number: 0281012881
- OEM number: 55209436
The ECU is intended for the Fiat Ducato 2.3 Multijet. Similar ECUs in stock: 0281010488 / 1329236080, 0281012881 / 552029450, 0281012881 / 552114950, 0281014209 / 51820662.
Cloning, options and warranty
Cloning on request is free – send the faulty ECU or files from it and we will transfer the data to this unit. For an extra charge we do chip tuning, EGR OFF and DPF OFF. Warranty: 6 months.
The condition we ship it in
A working, used ECU – tested on the bench and in a test vehicle before it goes out.
Full range in this group: Fiat Engine Control Units (ECUs).
Questions and answers – ECU 0281012881
Does ECU 0281012881 fit my Ducato?
Compare the label: Bosch number 0281012881 and OEM number 55209436. If both match, the ECU fits – the car model alone does not decide this.
|
Is Virgin or IMMO OFF better?
Virgin – it codes itself to the car and leaves no error. With IMMO OFF the immobiliser error and red message stay until the immobiliser is programmed.
|
Will you clone the data?
Yes, on request and at no extra charge. Just send the faulty ECU or files from it.
|
