What to know about ECU 0281017388 9666986880
On this page you can buy a Bosch EDC16C34 engine control unit for Peugeot and Citroën with the 1.4 / 1.6 HDi engine. The ECU is used and tested before dispatch.
After purchase, please send us your vehicle details: model, engine capacity and gearbox type.
Failure symptoms – what to look for
- the car will not start, the injectors are not controlled,
- the diagnostic tester cannot connect to the ECU,
- the fuses are fine, but the ECU has no power,
- the problem appeared after water ingress or a wiring short circuit.
The cause can also be wiring, power supply or sensors. Before you buy an ECU, have the car diagnosed.
Preparation and fitting
- IMMO OFF – plug & play: the immobiliser is disabled, so after fitting the ECU needs no programming or pairing with the immobiliser.
- After purchase, tell us the vehicle model, engine capacity and gearbox type.
- EGR OFF and DPF OFF on request – DPF OFF only for cars with a DPF.
- Free cloning: if you send us your ECU, we will transfer the data from it.
- Warranty: 6 months.
Vehicle compatibility
The ECU fits selected versions of Peugeot and Citroën with the 1.4 / 1.6 HDi engine. The numbers on the label (0281017388, 9666986880) decide the match, not just the car model and year. If you are not sure, send us a photo of your ECU label.
ECU 0281017388 numbers
The label of this unit shows:
- Bosch number: 0281017388
- PSA number: 9666986880
- ECU type: Bosch EDC16C34
See also
You will find more engine ECUs in the Peugeot and Citroën categories. All units from this manufacturer are listed on the Bosch page.
Common questions about ECU 0281017388
How can I check that 0281017388 will fit?
Look at the label on your ECU. It must show the numbers 0281017388, 9666986880 – the car model and year are not enough.
|
What vehicle details should I send after purchase?
The vehicle model, engine capacity and gearbox type.
|
Can I order EGR OFF or DPF OFF?
Yes, on request. DPF OFF is only done if the car is fitted with a DPF.
|
Will 0281017388 work without programming?
Yes. The immobiliser is disabled (IMMO OFF), so after fitting the ECU needs no programming or pairing with the immobiliser.
|
