Magneti Marelli 55201188 – Dualogic Gearbox Controller for Fiat Idea and Lancia Musa
Gearbox controller 55201188 CFC208F.10 is an original Magneti Marelli module designed for Fiat and Lancia vehicles equipped with the semi-automatic Dualogic / Selespeed gearbox. The offered controller is a used original part, fully tested and covered by warranty.
Every unit undergoes diagnostic communication testing and verification of gearbox electronics operation before sale. The module comes from an original vehicle and is not an untested dismantled controller.
Gearbox Controller Part Numbers
- 55201188
- CFC208F.10
- CFC208F10
- 62000.044.01
- Magneti Marelli CFC208
Application of Module 55201188
The CFC208F.10 gearbox controller is commonly found in:
- Fiat Idea 1.3 Multijet / JTD Dualogic,
- Lancia Musa 1.3 Multijet,
- selected versions equipped with Magneti Marelli semi-automatic transmission.
The module was mainly used in vehicles produced approximately between 2004–2011 with 1.3 JTD / Multijet 16V diesel engines.
Controller selection must always be based on the exact part number printed on the module housing. Different gearbox electronics versions were used in these models.
Typical Symptoms of CFC208F10 Gearbox Controller Failure
- gearbox remains in neutral position,
- unable to engage gears,
- Dualogic gearbox fault codes stored in memory,
- jerking during gear changes,
- no communication with gearbox controller,
- gearbox emergency mode activated,
- gear actuator or selector problems.
Common failures in Magneti Marelli CFC208 modules include power supply section damage, CAN communication faults and gearbox electronics control errors.
Tested Fiat / Lancia Gearbox Controller
The offered 55201188 module has been tested before sale and is covered by warranty. The controller is prepared for installation and possible gearbox adaptation procedures.
Repair Service for CFC208F.10 Gearbox Controller
If your original Fiat Idea / Lancia Musa CFC208F10 gearbox controller is damaged, professional diagnostics and repair may also be possible. We repair communication faults, gearbox control errors and internal electronics damage in Dualogic controllers.
FAQ – Gearbox Controller 55201188 CFC208F.10
Does controller 55201188 fit Fiat Idea 1.3 Multijet?
Yes, the 55201188 CFC208F.10 module is used in selected Fiat Idea 1.3 Multijet models equipped with Dualogic gearbox.
Which gearbox uses CFC208F10 controller?
The CFC208F10 module controls Magneti Marelli Dualogic / Selespeed semi-automatic transmissions.
Is CFC208F.10 installed in Lancia Musa?
Yes, the CFC208F.10 controller is also found in selected Lancia Musa 1.3 JTD versions.
What symptoms can a faulty Fiat Dualogic controller cause?
The most common symptoms include inability to shift gears, gearbox stuck in N position, gearbox warning errors and communication problems.
Is controller 55201188 tested before shipping?
Yes, every module undergoes communication and functionality testing before shipment.
Can CFC208 gearbox controller be repaired?
Yes, many Magneti Marelli CFC208 controller faults can be successfully repaired after professional diagnostics.
Do Fiat Idea and Lancia Musa use the same gearbox controller?
Some versions use identical Magneti Marelli modules, but compatibility must always be confirmed using the exact part number.
